First-co FRR Uživatelský manuál stáhnout pdf

NOTE: Read the entire installation instruction manual before starting the installation.

SAFETY CONSIDERATIONS

Improper installation, adjustment, alteration, service, maintenance, or use can cause explosion, fire, electrical shock, or other

conditions which may cause personal injury or property damage. Consult a qualified licensed installer, service agency, or

your distributor for information or assistance. The qualified licensed installer or service agency must use factory-authorized

kits or accessories when servicing this product. Refer to the individual instructions packaged with kits or accessories when

installing.

Follow all safety codes. Wear safety glasses and work gloves. Use quenching cloth for brazing operations. Have fire

extinguisher available. Read these instructions thoroughly and follow all warnings or cautions attached to the unit. Consult

local building codes and National Electrical Code (NEC) for special requirements.

Recognize safety information. This is the safety-alert symbol . When you see this symbol on the unit and in instruc-

tions manuals, be alert to the potential for personal injury.

Understand the signal words DANGER, WARNING, CAUTION, and NOTE. These words are used with the safety-alert

symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING

signifies hazards which could result in personal injury or death. CAUTION is used to identify unsafe practices which would

result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in

enhanced installation, reliability, or operation.

WARNING: Before installing or servicing unit, always turn off all power to unit. There may be more than

one disconnect switch. Turn off accessory heater power if applicable. Electrical shock can cause personal

injury or death.

INSTALLATION, OPERATION & MAINTENANCE INSTRUCTIONS

RR / RM / RS

**WARNING TO INSTALLER, SERVICE PERSONNEL AND OWNER**

Altering the product or replacing parts with non authorized factory parts voids all warranty or implied warranty

and may result in adverse operational performance and/or a possible hazardous safety condition to service

personnel and occupants. Company employees and/or contractors are not authorized to waive this warning.

Current Maintenance Program is available at www.firstco.com under "Product Information".

L2760 06/08

1 2 3 4 5 6 7

Shrnutí obsahu

Strany 1 - RR / RM / RS

NOTE: Read the entire installation instruction manual before starting the installation.SAFETY CONSIDERATIONSImproper installation, adjustment, altera

Strany 2 - INSTALLATION

GENERALThe manufacturer assumes no responsibility for equipment installed in violation of any code requirement.These instructions give information rel

Strany 3

PROCEDURE 2 – INSTALL AIR HANDLERCAUTION: Extreme caution must be taken that no internal damage will result if screws or holes are drilledinto the ca

Strany 4

4Route field power supply to the junction box at the front of the return air opening. Install in accordance with the unit wiringdiagram and all applic

Strany 5 - 3,4,6,8 blower

5PROCEDURE 5 - FINAL PREPARATIONInstall thermostats and perform any other final wiring required.Vacuum dirt and debris from cabinet interior and check

Strany 6 - Up & Down

6Coil CleaningRemove return air grille and filter, then brush fins up and down, not side to side, with a stuff bristle brush. Follow with avacuum cle

Strany 7 - CARE AND MAINTENANCE

CARE AND MAINTENANCEFor continuing high performance, and to minimize possible equipment failure, it is essential that periodic maintenance beperformed

Příbuzné modely FRM | FRS |

Komentáře k této Příručce

Žádné komentáře

First-co FRR Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Zařízení First-co FRR. First Co FRR User Manual Uživatelská příručka

Shrnutí obsahu

Příbuzné modely FRM | FRS |

Komentáře k této Příručce

Související produkty a manuály pro Zařízení First-co FRR